Panasonic S-200PE2E5 Technical Data & Service Manual page 96

1
Air outlet blocking patterns
As seen from underneath the indoor unit
● When a 2- or 3-way air outlet configuration is used or when the
air outlet duct connection flange (Φ150):field supply
is connected, block the air outlets as per the air outlet blocking
patterns illustrated below.
Also, refer to the table below, and decide on where the pipings
are to be positioned.
(To better understand what the illustrations show, refer to the
figure on the right.)
Note: Take care to prevent cold air leaks and deficient insulation
while performing the air outlet duct connection flange
(Φ150):field supply work in order to prevent condensation
from forming.
● It should be borne in mind that any air outlet blocking pattern with
the hatching mark will make it impossible for the "nanoe"
nano-technology fine particle function to work.
● When the air-flow blocker has been provided in any air outlet
blocking pattern with the hatching mark, set the "nanoe" function
to "off" using the remote controller.
● Under no circumstances must any air outlet blocking patterns not
shown in the table below be used.
3-way air outlet
One outlet can be
blocked.
2-way air outlet
Two outlets can be
blocked.
Air outlet duct
connection flange
(Φ150):field supply
connection 3-way air
outlet
One outlet can be
blocked and
connected to a duct.
Air outlet duct
connection flange
(Φ150):field supply
connection 2-way air
outlet
Two outlets can be
blocked and
connected to a duct.
Note: The duct can
be connected
only in one of
the locations
shown.
■ Changing the DC fan tap settings
While referring to "Selecting the DC fan motor taps," change the DC fan speed by using the wired remote
controller or by setting the DIP switches on the indoor unit control PCB.
AMP Air Conditioning
Air outlet duct
connection flange
(Φ150):field supply
Blocking area
<4>
"nanoe"
air outlet
Refrigerant
piping
1-90
www.ampair.co.uk | sales@ampair.co.uk
<3>
Air outlet
direction
<2>
Drain
<1>
piping