Automatic Address Setting - Panasonic S-200PE2E5 Technical Data & Service Manual

Automatic address setting

<Procedure of CZ-RTC5A>
1 Keep pressing the
buttons simultaneously for 4 or more seconds.
The "Maintenance func" screen appears on the
LCD display.
2 Press the or
menu.
If you wish to see the next screen instantly, press
the or
Select "9. Auto address" on the LCD display and
press the button.
Maintenance func
9. Auto address
10. Set elec. consumption
11. Set touch key
12. Check touch key
Sel.
3 The "Auto address" screen appears on the LCD
display.
Change the "Code no." to "A1" by pressing the
or button.
Auto address
Code no.
A1
Sel. Next
4 Select the "O/D unit no." by pressing the
button.
Select one of the "O/D unit no." for automatic
address by pressing the
Then press the
Approximately about 10 minutes are required.
When automatic address setting is completed, the
units return to normal stopped status.
AMP Air Conditioning
, and
button to see each
button.
20:30 (THU)
Page [ ] Confirm
20:30 (THU)
O/D unit no.
1
or button.
button.
[
Checking indoor unit addresses
1 Keep pressing the
buttons simultaneously for 4 or more seconds.
The "Maintenance func" screen appears on the
LCD display.
1. Outdoor unit error data
2. Service contact
3. RC setting mode
4.Test run
or
2 Press the
menu.
If you wish to see the next screen instantly, press
the or
Select "7. Simple settings" on the LCD display and
press the
5. Sensor info.
6. Servicing check
7. Simple settings
8. Detailed settings
The "Simple settings" screen appears on the LCD
display.
Select the "Unit no." by pressing the
button for changes.
Simple settings
Unit no.
The indoor unit fan operates only at the selected
indoor unit.
7-23
www.ampair.co.uk | sales@ampair.co.uk
20:30 (THU)
]
START
CZ-RTC5A
Fig. 7-12
, and
Maintenance func 20:30 (THU)
Sel. Page [ ] Confirm
or button to see each
button.
button.
Maintenance func 20:30 (THU)
Sel. Page [ ] Confirm
20:30 (THU)
Code no. Set data
3-1 01 0001
Sel. Next
7
or