Panasonic S-200PE2E5 Technical Data & Service Manual page 249

3. Wiring the Receiver
Wiring Diagram
Connections
Connect the wires from the receiver to the remote controller terminal strip on the indoor unit. (Polarity does not matter)
4. Setting for Receiver
Check the settings of the [S003] DIP switch on the
receiver's PCB.
* Remove the cover from the receiver
when performing the PCB settings.
5. Setting Address Switches
When more than 1 receiver is installed in the same room, setting addresses prevents interference.
For how to change addresses of wireless remote controllers, see the operating instructions of wireless remote controllers.
To change the receiver's address, remove the cover from the receiver's PCB and set No.1 to No.3 of the [003] DIP switch
on PCB.
Remote
Address
Controller
Address
Display ALL
Receipt is
Position of
possible at
the receiver's
all of the
address
address
switch
positions
AMP Air Conditioning
Indoor Unit
Terminal Strip for
Wiring Remote
Controllers
Address Address
1 2
1 2 3 4 1 2 3 4
Receiver PCB
White
Black
PCB cover
Receiver PCB
Address Address Address
3 4
1 2 3 4 1 2 3 4 1 2 3 4
8-21
www.ampair.co.uk | sales@ampair.co.uk
All set at OFF
when shipped
Screw
from the factory.
ON
Main/Sub selector
1 2 3 4
switch for remote
controllers (4)
OFF: Main
ON: Sub
Set its address
(1) to (3)
Address
ON/OFF
States
5 6
OFF ON
1 2 3 4
8