Operation - Crestron DigitalMedia DM-MD6X4 Installation & Operation Manual

Crestron DM-MD6X4/DM-MD6X6

Operation

Installation & Operation Guide – DOC. 7196B
A signal input to the DM-MD6X4 and DM-MD6X6 can be routed to up to four
outputs on the DM-MD6X4 or up to six outputs on the DM-MD6X6. Use the front
panel controls on the DM-MD6X4 or DM-MD6X6 to route an input signal to outputs
or to disconnect routed signals.
NOTE: Crestron Toolbox can also be used to control the routing of signals.
For more information, refer to the embedded Crestron Toolbox help file.
Routing an Input Signal to Output(s)
An input signal can be routed to one or more outputs simultaneously.
To route an input signal to output(s), use the following procedure:
1. Ensure that the home screen is displayed on the front panel LCD screen.
If it the home screen not displayed, press the HOME button. The home
screen is shown below.
Home Screen (DM-MD6X6 Shown)
When the home screen is displayed, the DM-MD6X4 or DM-MD6X6 is in
Route mode.
NOTE: By default, the input LEDs on the DM-MD6X4 or DM-MD6X6
are not lit. The output LEDs of unrouted outputs light.
2. Press the appropriate INPUT button that corresponds to the input to be
routed. INPUT buttons are numbered 1–6.
The LED of the selected input lights. In addition, video and audio
information about the selected input is provided on the LCD screen. The
LED(s) of output(s) currently routed to the input also light.
3. Press the appropriate OUTPUT button(s) that correspond to the desired
output(s).
NOTE: For the DM-MD6X4, up to four OUTPUT buttons, numbered
1–4, can be pressed for the selected input. For the DM-MD6X6, up to six
OUTPUT buttons, numbered 1–6, can be pressed for the selected input.
The LED(s) of the selected output(s) flash. In addition, the following
message appears on the LCD screen:
Press Select to Route
Press Back to Cancel
DigitalMedia Distribution Center: DM-MD6X4/DM-MD6X6 • 39
DigitalMedia Distribution Center