Program Checks - Crestron DigitalMedia DM-MD6X4 Installation & Operation Manual

DigitalMedia Distribution Center
USB Connections
Ethernet Connections
38 • DigitalMedia Distribution Center: DM-MD6X4/DM-MD6X6
5. From the list in the Address Book, select the entry listed for the
DM-MD6X4 or DM-MD6X6 (the address is listed as USB or TCP/IP), and
then click OK.
The DM device list is displayed, and the checkbox of the DM-MD6X4 or
DM-MD6X6 firmware is automatically selected. In addition, the checkbox
of any receiver/room controller connected to the DM-MD6X4 or
DM-MD6X6 is automatically selected if the firmware of the receiver/room
controller needs to be upgraded.
6. Click Update.
7. After the process is complete, click Recheck to verify the upgrade.

Program Checks

Actions that can be performed on the DM-MD6X4 and DM-MD6X6 vary depending
on whether it is connected via USB or Ethernet.
For USB connections, display the System Info window in Crestron Toolbox (click
the icon), and select the Functions menu to display actions that can be
performed on the DM-MD6X4 and DM-MD6X6.
For Ethernet connections, display the System Info window in Crestron Toolbox
(click the icon), and select the Functions menu to display actions that can be
performed on the DM-MD6X4 and DM-MD6X6.
Be sure to use Crestron Toolbox to create the DM-MD6X4 or DM-MD6X6 IP table.
1. Select Functions > IP Table Setup.
2. Add, modify, or delete entries in the IP table. The DM-MD6X4 or
DM-MD6X6 can have only one IP table entry.
3. A defined IP table can be saved to a file or sent to the device.
Edit the control system's IP table to include an entry for the DM-MD6X4 or
DM-MD6X6. The entry should list the IP ID of the DM-MD6X4 or DM-MD6X6
(specified on the IP table of the DM-MD6X4 or DM-MD6X6) and the internal
gateway IP address 127.0.0.1.
DMTool
In the Crestron Toolbox Address Book, select the DM-MD6X4 or DM-MD6X6.
Then, use DMTool to configure EDID, HDCP, or to troubleshoot AV on the
DM-MD6X4 or DM-MD6X6. Refer to the embedded help file for additional
information. To access DMTool, click the DMTool icon in Crestron Toolbox as
shown in the below image. DMTool can also be accessed by navigating to
Tools > DMTool.
DMTool
Crestron DM-MD6X4/DM-MD6X6
DMTool
Installation & Operation Guide – DOC. 7196B