Network - Crestron DigitalMedia DM-MD6X4 Installation & Operation Manual

Crestron DM-MD6X4/DM-MD6X6
Installation & Operation Guide – DOC. 7196B
•
For outputs 2–4 (DM-MD6X4) and outputs 2–6 (DM-MD6X6), view
information such as the firmware version and the IP address of the
connected DM 8G+ receiver/room controller. To do so, navigate to the
model name of the connected DM 8G+ device on the Output submenu,
and then press the Select button.
NOTE: For output 1, HDMI is always displayed on the Output
submenu. Pressing the Select button displays HDMI again.
•
View Video EDID information. To do so, navigate to Video EDID on
the Output submenu and then press the Select button.
•
View Audio EDID information. To do so, navigate to Audio EDID on
the Output submenu and then press the Select button.

Network

Ethernet settings can be configured for the DM-MD6X4 and DM-MD6X6 by
configuring network parameters. Network parameters include the following:
•
IP Address (applicable only if DHCP [Dynamic Host Configuration
Protocol] is disabled): Allows adding or editing a static IP addres
•
Subnet Mask (applicable only if DHCP is disabled): Allows adding or
editing a subnet mask address
•
Default Router (applicable only if DHCP is disabled): Allows adding or
editing a default router address
•
DHCP: Allows DHCP to be enabled or disabled
NOTE: DHCP is enabled by default.
•
Control System: (the IP ID of the DM-MD6X4 or DM-MD6X6 and the IP
address of the control system): Allows adding and editing control system
parameters
In addition, the network status can also be viewed.
To view network status or to configure network parameters, use the following
procedure:
NOTE: Changes to network parameter settings take effect when the
DM-MD6X4 or DM-MD6X6 exits Installer mode and the device automatically
reboots. A message appears on the LCD screen indicating that the device is
rebooting. For information about exiting Installer mode, refer to "Exiting Installer
Mode" on page 31.
1. Access the Installer menu screen. (Refer to "Accessing Installer Mode" on
page 21.)
NOTE: If the DM-MD6X4 or DM-MD6X6 is already in Installer mode,
press the BACK button on the front panel until the Installer menu appears.
2. Navigate to Network, and then press the Select button on the navigation
pad.
The Network submenu appears as shown on the following page. The
submenu is scrollable as indicated by the bar on the right side of the screen.
DigitalMedia Distribution Center: DM-MD6X4/DM-MD6X6 • 25
DigitalMedia Distribution Center