Crestron DM-MD6X4/DM-MD6X6
Installation & Operation Guide – DOC. 7196B
The screen returns to the Control System submenu.
IP Address: Accesses the Ctrl Sys IP Addr configuration
o
screen, which allows the IP address of the control system to be
entered.
Enter the control system IP address using the navigation pad.
For each octet in the IP address, press the Up or Down
navigation button until the desired number appears, and then
press the Select button.
NOTE: If necessary, the Left or Right navigation button can
be used to navigate to an octet in the control system IP
address.
The screen returns to the Control System submenu after the
last octet is selected.
Control
The following control parameters can be configured:
•
Backlight: Allows the brightness of the front panel LCD screen to be
adjusted
•
Password: Allows the Installer password to be changed or disabled
•
Front Panel:Lock: Prevents or allows changes to signal routings
•
Restore Defaults: Restores the device to factory settings
In addition, firmware version information about the DM-MD6X4 or DM-MD6X6
and connected DM 8G+ receivers/room controllers can be viewed.
To configure control parameters or to view firmware version information, use the
following procedure:
1. Access the Installer menu screen. (Refer to "Accessing Installer Mode" on
page 21).
NOTE: If the DM-MD6X4 or DM-MD6X6 is already in Installer mode,
press the BACK button on the front panel until the Installer menu appears.
2. Navigate to Control and then press the Select button on the navigation pad.
The Control submenu appears as shown below.
Control Submenu
DigitalMedia Distribution Center: DM-MD6X4/DM-MD6X6 • 29
DigitalMedia Distribution Center