Exiting Installer Mode - Crestron DigitalMedia DM-MD6X4 Installation & Operation Manual

Crestron DM-MD6X4/DM-MD6X6
Installation & Operation Guide – DOC. 7196B
•
Restore the DM-MD6X4 or DM-MD6X6 to its factory settings as
follows:
a. Navigate to Restore Defaults and then press the Select button.
The Restore Defaults configuration screen appears.
b. Press the Down button on the navigation pad to highlight Yes, and
then press the Select button.
A prompt appears asking you whether you are sure you want to
restore the default settings.
c. Select Yes to restore the default settings or No to cancel.
The screen returns to the Control submenu.
•
View firmware information about the DM-MD6X4 or DM-MD6X6
and connected DM 8G+ receivers/room controllers. To do so, navigate
to About and then press the Select button.

Exiting Installer Mode

To exit Installer mode, return to the home screen by pressing the HOME button.
NOTE: The home screen can also be accessed by pressing the BACK button as
necessary or by allowing the DM-MD6X4 or DM-MD6X6 to time out after
30 seconds of inactivity.
DigitalMedia Distribution Center: DM-MD6X4/DM-MD6X6 • 31
DigitalMedia Distribution Center