Table of Contents
Advertisement
15. Press <esc.> to continue. Press <esc.> again to exit
the FDISK Main Menu. You will be informed that you
need to reboot the system. Press <esc.> to exit FDISK.
At the DOS prompt, press Ctrl+Alt+Del to reboot the
system.
16. The system will reboot to the CD-ROM. You must now
format all partitioned segments of the hard drive.
17. At the DOS prompt, type:
Format C:/S/U and press <Enter>.
(There must be a space between the word "format" and
"C")
This will format the primary partition C, and copy all
system files to the primary drive. If you have created
more than one partition you must format them as well.
To format the D drive for example, at the DOS prompt
type:
Format D:/U and press <Enter> (There must be a space
between the word "format" and "D".)
18. Continue until all partitions have been formatted. At the
completion of Format Disk, you will be returned to the
DOS prompt. Refer to the following section on how to
run the PHDISKF Utility.
PHDISKF Utility
You will need to create a DOS File segment on the hard drive in
order to take advantage of the Save to Disk Power Management
Feature. The DOS file can be created before or after you install
the operating system. Creating the DOS file after the installation
of the operating system will NOT erase any data from the hard
drive. For the purpose of these instructions, we have decided to
first create the DOS file and then install the operating system.
To use the PHDISKF utility, please refer to the following
instructions:
System Restoration
2-15
Advertisement
Table of Contents
