Feeding The Stitching Wire - Hohner UNIVERSAL 43/6 S Operating Instructions Manual

3.2 Feeding the stitching wire

- Fig. 9 -
- Shut off the wire transport (move triangular handle
- Push the stitching wire through from above, as follows:
through the eyes of the wire guide - between the two felt disks
lock - through the wire guidance tube
- Restart the wire transport (turn triangular handle
- Mount adjusting handle
- Convey the wire to the knife by turning the adjusting handle
3.3 Removing the stitching wire
- Shut off the wire transport (move triangular handle
- Press adjusting disk
and pull the wire out.
3.4 Removing the wire guide tubes in the event of a wire jam
- Fig. 10 -
If a wire jam has occurred in the area of the wire guide tubes, this can be eliminated more easily
by removing the wire guide tubes.
- Shut off the wire transport (move triangular handle
- Loosen the clamping screw
- Disentangle wire and remove from wire guide tubes.
- Press adjusting disk
and pull wire out.
Hohner Maschinenbau GmbH
and between the two feed wheels
.
on wire return lock downwards, in order to eliminate its clamping effect,
(slotted or Torx screw) and remove wire guide tubes
on wire return lock downwards in order to eliminate its clamping effect
HK 43/6 S
until you see the feed wheels disengaged).
through into the wire return
to the left).
to the right.
until you see the feed wheels disengaged).
until you see the feed wheels disengaged).
Operation
.
25