Installation Of The Stitching Head - Hohner UNIVERSAL 43/6 S Operating Instructions Manual

3.1 Installation of the stitching head

3.1.1 Clamping the stitching head
- Fig. 4 -
The stitching head is held by a tenon block which is inserted into the stitching head mounting on
the machine.
- Unscrew tenon block from the stitching head with Allen key SW4
- Introduce tenon block laterally into the stitching head mounting
- Insert stitching head into stitching head mounting, so that the driver lug
the stroke bar and the tenon block fits into the stitching head.
- Fix the stitching head by tightening the tenon block in the stitching head mounting using the Allen
key .
3.1.1.1 Lateral adjustment of the stitching head
- Fig. 4, Fig. 5 -
The center of the wire formed parts within the stitching head must be set to the desired stitching
position for the wire stitch by lateral adjustment.
- Loosen the tenon block
- Move the stitching head sideways, until the desired position is reached.
- Fix the tenon block in the stitching head mounting
3.1.1.2 Front adjustment of the stitching head
- Fig. 5 -
The lifting movement of the wire formed parts must drive the stitch accurately into the clincher box
forming gap. (Cf. Chap. 3.1.4). If the center of the wire stitch is located too far in front of or behind
the clincher box, or if the lifting movement is not precisely aligned with the clincher box, this can be
corrected by adjusting the set screws
- Remove stitching head.
- Adjust set screws .
- Fit stitching head.
Hohner Maschinenbau GmbH
with the Allen key .
on the stitching head.
HK 43/6 S
.
.
can be inserted into
with the Allen key.
Operation
17