Removing The Bender Stop - Hohner UNIVERSAL 43/6 S Operating Instructions Manual

Servicing

4.2.2 Removing the bender stop

- Fig. 25 -
The bender stop dictates the lower position of the bender. This stop ensures that the bender does
not strike against the product during stitching of thin products and can damage them. The basic
setting of the bender stop is performed at the factory.
Before removing the bender stop read off and record the position of the left edge of the slide
on the scale , so that you can subsequently reset the bender stop to the same position.
- Unscrew the screw and remove bender stop with slide .
Installation is performed in the inverse order.
- First, screw in the screw lightly.
- Reset the slide by moving it to the read off scale value (arrow).
- Tighten the screw.
45
Hohner Maschinenbau GmbH HK 43/6 S