Setting The Leg Length Of The Stitch - Hohner UNIVERSAL 43/6 S Operating Instructions Manual

3.6.3 Setting the leg length of the stitch

- Fig. 13 -
The leg length of the stitch is dependent on the thickness of the product to be stitched. The knife
box can be adjusted in order to adapt to the thickness of the product. The end of the scale pin
marks the set value for the stitch thickness in mm. The upper values
serve to set stitching thicknesses for normal stitching and the lower values
- 2) serve to set the thickness for loop stitching.
- Adjust knife box by turning the knurled wheel
of the required stitch thickness (in mm) on the relevant scale.
- Test the leg length by a test stitch.
- Set the stitch to precisely the same leg length by turning the knurled wheel
Normal stitch
move thumbwheel down
until the gap is centered
Loop stitch
move thumbwheel down
until the gap is centered
Hohner Maschinenbau GmbH
, until the end of the pin
move thumbwheel up
until gap is centered
move thumbwheel up
until gap is centered
HK 43/6 S
Operation
on the scale (1 - 7)
on the scale (-L-, 0
indicates the value
.
31