Spine Centering Parts - Hohner UNIVERSAL 43/6 S Operating Instructions Manual

3.8 Spine centering parts

The spine centering parts are only used for saddle stitching. They help to precisely position the
stitch in the center of the sheet fold
3.8.1 Fitting the holding down device - "old" model
- Fig. 18 -
- Attach tension spring
- Mount distance plate
In the case of loop stitching an additional distance plate
would touch the centring V-block
- Place complete rod assembly
housing with the help of the two countersunk screws
- Ensure that the rod assembly runs smoothly.
3.8.2 Fitting the slide
- Fig. 18b -
- Insert slotted screw
- Fix slide with slot on slotted screw and tighten lightly using the locking nut
- Push the complete slide
- Align the V-block of the slide to the center of the clincher box with the help of the M5 setscrew
.
- Set the height of the V-block to approx. 0.5 mm above the clincher box.
- Tighten the locking nut
3.8.3 Setting the holding down device
- Fig. 18, Fig. 18a, Fig. 18b -
The centring V-block
the edge of the bender. This can be adjusted by moving the plate
- Install stitching head in the stitching unit (cf. 3.1). You must ensure that the locating key
the plate is positioned on the lifting bar and is not, as is the case with the stitching head
locating key, inserted into the locating groove (cf. Fig. 18a).
- Loosen the 2 countersunk screws
- Drive rod linkage into plate
mm beneath the edge of the bender.
- Tighten the 2 countersunk screws
The centring V-block
- Move centring V-block
the V-block of the slide
Hohner Maschinenbau GmbH
(cf. Fig. 17)
to the two spring bolts
on stitching head.
.
with the guide plate
laterally into the clincher box mounting.
against the clincher box.
.
on the lower part of the rod linkage should lie approx. 3 - 5 mm beneath
.
until the lower part of the rod linkage is positioned approx. 3 - 5
.
can be moved backwards or forwards by turning the adjusting screw
far enough backwards or forwards so that it is precisely aligned with
(see Fig. 18b)
HK 43/6 S
.
is required as otherwise the longer wire
on the distance plate and fix to the
.
in the slot.
Operation
.
of
.
35