Adjusting The Clincher Box - Hohner UNIVERSAL 43/6 S Operating Instructions Manual

Operation

3.1.4 Adjusting the clincher box

- Fig. 8a -
The center of the bender inside the stitching head must be precisely aligned to the center of the
clincher box.
- Loosen locking nuts (or clamping screws) (and locking screws).
- Move clincher box until it is precisely aligned with the center of the bender.
- Fix clincher box by tightening the locking nuts (or clamping screws) (and locking screws).
Using the clincher box setting gauge
- Fig. 8b, Fig. 8c -
- Remove former (see 4.2.1). Place gauge on former locating pin and turn downward against
stopper. The clincher box can be precisely aligned by aligning the gauge with the scale graduation
marks.
- Tighten clamping nut and remove gauge . Fit in former.
23
Hohner Maschinenbau GmbH HK 43/6 S