Replacing The Driver (Normal Stitch) - Hohner UNIVERSAL 43/6 S Operating Instructions Manual

4.2.5 Replacing the driver (normal stitch)

- Fig. 36, Fig. 37 -
The driver can be used twice (only with normal stitching). If one side is damaged or deflected,
the driver can be turned round.
Drivers and benders are numbered
matching benders ( see table below ), as their wire guiding grooves are different.
- Unscrew fastening screw
- Rotate driver.
or
- Change driver.
- Press shoe tongue
- Secure driver with fastening screw.
Round wire no. 24 - 26
Driver : 31 64 335
Round wire no. 26 - 28
Driver : 31 64 337
4.2.6 Replacing the driver (loop stitch)
- Fig. 38 -
- Unscrew setscrew
- Change driver.
- Press shoe tongue
- Secure driver with setscrews.
Standard loop stitch - L6 -:
Round wire no. 24 - 26
Driver -L-: 31 64 412
Loop stitch - L8 -:
Round wire no. 24 - 26
Driver -L-: 31 64 676
Hohner Maschinenbau GmbH
. Care must be taken that drivers are always used with
and push the driver
back and push driver into the bender from beneath.
with bender: 31 64 325
with bender: 31 64 327
and push the driver
back and push driver into bender from beneath.
with bender -L-: 31 64 441
with bender -L-: 31 64 679
down out of the bender.
down out of the bender.
HK 43/6 S
Servicing
51