Ejecting And Tearing Off A Form - Printek FORMSMASTER 8000SE Operator's Manual

D A I L Y O P E R A T I O N

Ejecting And Tearing Off A Form

When most print jobs complete, they will command the paper to be
positioned at the top of the next form so that the printer is ready for the next
job. This is, however, dependent solely upon how the programmer chose
to write your particular application software. If your software does position
the paper at the top of the next form, the printer will automatically position
the form at the tear bar as shown in the following picture.
If your form is positioned as shown, you may skip the next section on
positioning and proceed with "
Positioning the Form for Tear Off
1. If your print job has completed and the form is not positioned as
shown above, take the printer off line by pressing the ONLINE button
(indicator will change from green to flashing red).
2. Press the FORM FEED button. This will automatically position the
form at the tear bar and you may tear off the form as described
below.
32
Bottom of form at tear bar
Tearing off a Form
".