Stop Bits - Printek FORMSMASTER 8000SE Operator's Manual

P R I N T E R
Possible Values: 8*, 7
This item selects the number of data bits in the serial character frame. This
must be set to match the character size setting on the host computer.

Stop Bits

Possible Values: 1*, 2
This item sets the number of stop bits to be used at the end of the serial
character frame. This must be set to match the stop bit setting on the host
computer.
Parity
Possible Values: None*, Even, Odd
This item selects the parity checking requirements for the serial data bits.
This must be set to match the parity setting on the host computer.
Busy Signal Polarity
Possible Values: Low*, High
This item selects the polarity of the busy signal (pin 11 of the RS-232C
interface). Busy is set whenever the printer is offline, the serial input buffer
is full, or another interface port is currently active (see "
" earlier in this section).
Switching
Data Terminal Ready
54
C O N F I G U R A T I O N
Stop Bits
Parity
Busy Polarity
Automatic Port
Power On/Off
8
1
None
Low
DTR