Printek FORMSMASTER 8000SE Operator's Manual page 45

PRINT
The VALUE buttons will move the print down or up in 1/100
increments. Note again that the arrow will change according to the
direction the print is to be moved from the normal print position. The
maximum distance print may be moved is 9.99 inches in either direction.
Example
In this example, a number needs to be printed in a box on a preprinted
form. This form could be a packing list, an invoice, or a check. The first
time the page is printed, the number misses the box as shown below.
In this case, the print needs to be moved to the right and down. To
accomplish this, p ress ALIGN PRINT and access the
First move the print to the right using the VALUE buttons. It appears that
the text needs to move about three characters. If the text is being printed at
10 cpi (characters per inch), this would be 0.30 inches. After making this
adjustment the display would look as follows.
Left/Right
If you were to print this form now, it would appear as follows, showing that
the print still needs to be moved down.
To move the print down, access the
the ITEM buttons. It appears that the print needs to be moved down nearly
the height of the characters. These characters are approximately 0.10
inches tall, so move the print down about 0.08 inches. The display should
look as follows.
MOVE
Down/Up
0.00"
×
12345
MOVE
PRINT
0.30"
12345
D A I L Y
Down/Up option by pressing either of
O P E R A T I O N
th
Left/Right
option.
inch
37