Formsmaster 8003Se Tritrak™ Model - Printek FORMSMASTER 8000SE Operator's Manual

G E T T I N G
making sure that the paper will not extend above the top of the
tractors. Then close the tractor door.
Note: The left tractor position is not adjustable. If it is necessary
to adjust where printing begins, refer to "
in the "
5. Now position the paper in the right tractor in the same fashion. If
necessary, the position of the right tractor may be adjusted. To do
so, move the lever on the side of the tractor down to unlock the
tractor and slide the tractor sideways on the shafts. If necessary, the
paper guides between the tractors may be slid in either direction to
accommodate the form width. Make sure that the guides are spaced
evenly between the tractors.
After the paper is placed in the tractor and the door is closed,
position the tractor far enough to the right so that there is no buckle in
the paper between the tractors, but not so tight that the holes in the
paper are distorted. Lock the tractor in place by returning the lever
to the up position.
6. Close the paper door.
7. Press the LOAD button.
8. Place the printer on line by pressing the ONLINE button.
FormsMaster 8003se TriTrak™ Model
The following instructions will guide you through loading all three tractor
paths.
1. Make sure the printer is powered on and that the printer is off line
(ONLINE indicator flashing red).
2. Press the UNLOAD button to move the tractor shuttle forward to the
load position.
16
S T A R T E D
Daily Operation
" section of this manual.
"
Aligning Print