Mute Output - Extron electronics SSP 7.1 User Manual

Input 5 accepts a balanced or unbalanced analog input through a 5-pin captive screw
•
connector. The unit can be configured to accept:
•
•
•
•
The input can also be selected using the SSP 7.1 Setup and Control Software (see
selection

Mute Output

When the mute state is enabled, all channels are muted simultaneously. To toggle between mute
and unmute:
1. Press and hold the active input button (the button next to the LED that is lit).
2. While still holding the active input button, press the
When the mute state is enabled, the individual LEDs of the Volume Adjustment LED bar light in
sequence from the top down. This scrolling down pattern repeats while the mute state persists.
NOTES:
Selecting another input button while the mute function is enabled, disables the mute
•
function.
Adjusting the volume control encoder to change the volume (or the analog input gain)
•
settings while the mute function is enabled, disables the mute function and increases
(or decreases) the volume (or gain) from its previous setting.
If SIS commands have been used to mute a specific channel, muting and unmuting all
•
channels also unmutes the channel that was specifically muted. It does not remain in its
previously muted state.
All channels can also be muted using the SSP 7.1 Setup and Control Software (see
volume and mute
Complete System Reset
The SSP 7.1 has three levels of System Reset.
Standard system reset — All parameters that can be adjusted by the control program are
•
reset to default.
Factory reset — In addition to resetting all the parameters of the standard system reset,
•
the baud rate for communicating with the computer is also reset.
Complete system reset — In addition to resetting all the parameters of the factory reset,
•
the firmware is reset to the factory-installed version.
The standard and factory resets are performed using SIS commands (see the
the SIS commands on page 82).
To perform a complete system reset, press and hold the
off and restoring power.
A stereo signal
A mono signal from the right channel
A mono signal from the left channel
A mixed sum of right and left channels
on page 23).
on page 26).
Mode Override button.
Master
System Reset
button while shutting
Mode Override
SSP 7.1 • Panel Features
Input
in
9