Step 4 - Audio Output Connector; Step 6 - Remote Connector; Step 7 - Line Out Connector - Extron electronics NetPA AT Series Setup Manual

NetPA AT Series • Setup Guide (Continued)
Step 3 — Connecting the NetPA AT to the Network
Using standard CAT cable, connect the
Physical Dante Network
Step 4 — Audio Output Connector
Stereo audio output connector — Wire the speakers to the
screw connector, as shown below.
Do not tin the wires!
Mono audio output connector — Wire the speakers to the
captive screw connector, as shown below.
Do not tin the wires!
Step 5 — Setting the High Pass Filter (HPF)
On the NetPA 1001-70V AT, use a Tweeker or small screwdriver to toggle the
and 80 Hz (default). Setting the switch to 80 Hz prevents the saturation of speaker input transformers by low frequency signals.
The high pass filter can be safely turned off only if the filtering is applied upstream of the amplifier.
Step 6 — Remote Connector
The 3.5 mm, 2-pin captive screw
shorted to ground. The amplifier wakes from standby and resets the inactivity timer when the connection is reopened.
See the user guide for details.
Step 7 — Line Out Connector
Connect an amplifier or other device to the
(NetPA 502 AT) or the single channel (NetPA 1001-70V). Wire as shown below.
Audio Output Wiring
Tip
Ring
Sleeve
Balanced Output
" (5 mm) MAX.
Do not tin the wires!
NOTE:
The signal that comes out of the line output is the same signal that goes into the amplifier stage, prior to the gain
potentiometers. (The same audio content coming out of channel 1 amplified output comes out of the channel 1 line output.)
2
RJ-45 connector
on page 9).
S
U T
T P
O U
/ 4 Ω 2
8 Ω
1
G
I N
I R
2 W
S
A S
C L
T S
P U
U T
V O
7 0
G
I N
I R
2 W
S
A S
C L
remote control port
3-pole, 3.5 mm captive screw connectors
Tip
NO Ground Here
Sleeve
Unbalanced Output
ATTENTION:
For unbalanced audio outputs, connect the sleeves to the ground
contact. DO NOT connect the sleeves to the negative (–) contacts.
ATTENTION :
Pour l'audio asymétrique, connectez les manchons au contact
au sol. Ne PAS connecter les manchons aux contacts négatifs (–).
E of the NetPA AT to a LAN for digital audio transport (see
output connector of the NetPA 502 AT
output connector of the NetPA 1001-70V AT
high pass filter switch
D forces the unit into standby mode when the remote standby pin is
H
using the 4-pole captive
I
using the 2-pole
between Off (no filtering)
J
C
for channel 1 and channel 2
Creating a