Analog Outputs; Renaming Output Channels; Output Attenuation Dialog Box - Extron electronics AXI 22 AT User Manual

Analog Outputs

The AXI 22 AT has two analog outputs and the AXI 44 AT has four analog outputs. The AXI
analog outputs receive signal from the Dante network and appear on the Dante network as
Receiver channels.

Renaming Output Channels

Analog output names are read from the AXI Dante interface Receiver channel names but
can be changed from the DSP Configurator workspace. Analog output channel name
changes made in DSP Configurator are reflected in Dante Controller. Analog output name
changes made in Dante Controller are also reflected in DSP Configurator.
To rename an analog output channel:
1.
2.
3.
Figure 19.

Output Attenuation Dialog Box

Double-click the output attenuation block (
configure output attenuation settings.
1
2
3
4
5
6
7
8
Click the output name, the box becomes a text field with a flashing cursor.
Highlight or delete the text and enter the desired name.
Press on the keyboard or navigate away from the text field to apply the new
<Enter>
name. Press the
<Down Arrow>
Renaming an Output Channel
Output Name — This name matches the default or user
defined Dante Receiver channel name.
dBFS Meter — This meter displays the output signal level
in dBFS ranging from -60 dBFS to 0 dBFS. Once the signal
reaches or exceeds -1 dBFS (default) or the clip threshold
defined in the dialog box, the clip box located at the
Options
top of the meter lights red. A numerical readout of the output
level is located below the meter.
Output Attenuation Fader — Click and drag the fader to
adjust the attenuation level in 1 dB steps. Click the fader
once and press the
<Up Arrow>
adjust the attenuation in 1 dB steps. Use the
keys to adjust attenuation in 10 dB steps.
<Page Down>
Output Attenuation Text Box — Allows the user to enter an
attenuation value in 1 dB steps. The value must be a negative
number.
Mute Button — Mutes the signal at the output stage. When
the button is red, mute is engaged.
OK Button — Confirms changes made to the contained parameters and closes the
dialog box.
Attenuation
Cancel Button — Reverts any changes made to the contained parameters back to
their states when the current instance of the
closes the dialog box.
Attenuation Help Button — Opens the
Configurator Help file for further assistance in configuring output attenuation.
key to navigate to and highlight the next name field.
) to open the
Attenuation
or keys to
<Down Arrow>
<Page Up>
Attenuation
Output Attenuation
AXI 22 AT and AXI 44 AT • DSP Configurator Software
dialog box to
8
1
3
2
or
4
5
6 7
dialog box was opened and
topic of the DSP
19