Directed Electronics Viper 7652V Owner's Manual page 34

To perform Valet take-over:
1. Before turning off the engine, press and release
mitter. Then wait a few seconds.
2. Turn the ignition key to the OFF position (The engine will stay
running).
3. The engine will run until the pre-programmed time elapses or a
shut-down input is received.
Note: To enable Valet take-over with a manual transmission, open the
door when going into a manual transmission mode. After you exit
the vehicle you can arm the alarm and the car will remain running. If
the vehicle shuts down when arming, then the unit did not enter the
valet take-over mode.
34
on the trans-
© 2008 Directed Electronics. All rights reserved.