Related Manuals for Directed Electronics 5301
Summary of Contents for Directed Electronics 5301
- Page 1 Responder LE Model 5301 Remote Start Keyless Entry Owner’s Guide © 2008 Directed Electronics, Vista, CA G4202V 2008-05...
-
Page 3: Table Of Contents
Contents Government regulations ...5 Warning! Safety first ...6 What’s included ...9 Important information ...9 Your warranty...9 Replacement remotes...9 Responder LE 2-way remote ...10 1-way companion remote ...11 Transmitter configuration ...11 Out of range notification...16 System maintenance ...16 Low battery indicator ...16 Remote control progamming ...17 Multi-car control capability ...19 Locking the vehicle ...20... -
Page 5: Government Regulations
RF exposure compliance. This device is designed to be used in a person’s hands and its operating configurations do not support normal transmissions while it is carried in pockets or holsters next to a persons’ body. © 2008 Directed Electronics. All rights reserved. -
Page 6: Warning! Safety First
You must read this Owner’s Guide to familiarize yourself with the proper procedures regarding manual transmission remote starters. If you have any questions, ask your installer or contact Directed at 1-800-753-0600. © 2008 Directed Electronics. All rights reserved. - Page 7 The remote start module must be removed or the installer must properly reinstall the remote start system so that the vehicle does not start in gear. All installations must be performed by an authorized Directed dealer. © 2008 Directed Electronics. All rights reserved.
- Page 8 This product should not be installed in any convertible vehicles, soft,or hard top with a manual transmission. Installation in such vehicles may pose certain risk. © 2008 Directed Electronics. All rights reserved.
-
Page 9: What's Included
➤ Replacement remotes Your system comes with one Responder LE remote control (P/N 7251) and one remote control (P/N 7152). If additional remotes are desired, please see your authorized dealer or visit www.directedstore.com to order. © 2008 Directed Electronics. All rights reserved. -
Page 10: Responder Le 2-Way Remote
Back of remote has label to identify the remote as 2-way or 1-way. Remove to access batteries when necessary. For more detail, see p. 16 Flashes to indicate function confirmation and then press © 2008 Directed Electronics. All rights reserved. to exit. -
Page 11: 1-Way Companion Remote
A U X Trunk Release A U X A U X Function Shift* button must be pressed and held to access state © 2008 Directed Electronics. All rights reserved. Note: See call-out table for 2-way Silent Lock Silent Unlock Valet Mode Reset... - Page 12 This is an optional feature. See your sales rep/installer for details. Press 1 to 4 times. ( See Function shift table.) LED indicators turn on (according to the feature command) Each Press then release, shifts the function of the command button. © 2008 Directed Electronics. All rights reserved.
- Page 13 Screen will display current cabin temperatue. Notes Cabin temperature is displayed on the remote. LED lights turn on to indicate a range. (See p.29) © 2008 Directed Electronics. All rights reserved. one- time and then press one- time and then press one-time and then one time and then press one time, then Hold for 1.5 seconds.
- Page 14 A U X two times and then press A U X three-times and then A U X three-times and then press © 2008 Directed Electronics. All rights reserved. A U X A U X A U X A U X...
- Page 15 Feedback Remote start LED on, 1 beep. Notes Manually turns on the defogger when remote start is © 2008 Directed Electronics. All rights reserved. three times and then press three-times, and then Hold for 1.5 seconds. four times, and then...
-
Page 16: Out Of Range Notification
Note: The Lock/Unlock confirmations should be programmed On,and the op- tional horn honk installed, for the system to emit any additional honks during unlocking. Ask your authorized dealer if you have any questions. © 2008 Directed Electronics. All rights reserved. -
Page 17: Remote Control Programming
Lock LED Off: The keypad lock feature is Off and the keypad does not lock. The companion remote beeps twice wthen the feature is programmed © 2008 Directed Electronics. All rights reserved. button on the remote for 12 seconds. (ignore the button for 1. - Page 18 Aux LED Off: The remote does not wake up and listen for messages from the system to extend battery life. This means the remote does not receive , and then press to unlock the keypad. © 2008 Directed Electronics. All rights reserved.
-
Page 19: Multi-Car Control Capability
After you select the car number, press any command button to operate the features. The selected car remains selected until the setting is changed. © 2008 Directed Electronics. All rights reserved. button. The LEDs will change to indicate the car... -
Page 20: Locking The Vehicle
LED indicator to confirm locking. If no LED to confirm locking. If no lock confirmation button one time. The vehicle horn honks button on the remote one-time, and then © 2008 Directed Electronics. All rights reserved. button. The LED to confirm... -
Page 21: Overriding The Optional Starter Kill
If the override switch has been programmed to a new number of presses by your authorized dealer, that number should be indicated below. Override Switch number of presses ________ © 2008 Directed Electronics. All rights reserved. -
Page 22: Using The Remote Start
The hood is opened • When the remote start command is sent again from a remote control • When runtime expires button on the remote control. The vehicle parking A U X © 2008 Directed Electronics. All rights reserved. LEDs A U X... -
Page 23: Runtime Check
75% runtime remaining 50% runtime remaining 25% runtime remaining When the remote start and Function LEDs are blinking, there is less than three minutes of runtime left. © 2008 Directed Electronics. All rights reserved. button three-times and then hold A U X... -
Page 24: Manual Transmission Vehicles
Insert the ignition key and turn it to the On position. Now, step on the brake. The remote control plays the remote start shutdown tone. You have now taken direct control from the remote start system. © 2008 Directed Electronics. All rights reserved. -
Page 25: Timer Mode
To exit timer mode with the transmitter: • Press the button twice and then press four times to confirm timer mode is exited. © 2008 Directed Electronics. All rights reserved. twice and then press . The parking lights flash slow A U X A U X... -
Page 26: Turbo Timer Mode
Turn Off the ignition. The car remains running. Exit the vehicle and Lock the system. The vehicle remains running for the programmed run time. button 2-times, and then press © 2008 Directed Electronics. All rights reserved. A U X... -
Page 27: Smart Start Activation
The factory setting for temperature high is 100º, and the low is 0º (F). The voltage setting is 10.5v. These settings can be adjusted or turned off by your installer using the Bitwriter. © 2008 Directed Electronics. All rights reserved. - Page 28 Press the brake pedal The parking lights flash 5 times slowly to confirm the remote has exited Smart Start mode. button on the remote (the vehicle shuts © 2008 Directed Electronics. All rights reserved. button. A U X button. A U X...
-
Page 29: Cabin Temperature
To manually activate the rear defogger after remote start is on: • Press four times, and then press Note: if remote start is not active, the remote emits an error tone. © 2008 Directed Electronics. All rights reserved. A U X... -
Page 30: Valet Take-Over
After you exit the vehicle you can lock the system with the remote and the car remains running. If the vehicle shuts down when locking, then the unit did not enter the valet take-over mode. © 2008 Directed Electronics. All rights reserved. button on the A U X... -
Page 31: Safety Features
To disable the remote start, move the shutdown toggle switch to the Off position. Check with your installer for the location of the shutdown switch. Location of Shutdown Switch____________________________ © 2008 Directed Electronics. All rights reserved. -
Page 32: Diagnostics
➤ Unlocking Extra honks when unlocking the system is a notification that the batteries in the remote are low and need to be replaced. Important: installed. The optional horn honk feature must be © 2008 Directed Electronics. All rights reserved. - Page 33 8 flashes: neutral safety wire has no ground or the remote start defeat toggle switch is off. Keep a record of the number of flashes, to assist your installer when taking the vehicle in for service. © 2008 Directed Electronics. All rights reserved.
-
Page 34: Owner Recognition
(ignition is not turned on) for a one-hour period while the system is in Valet Mode, the status LED shuts Off. If the system remains in Valet Mode, the LED comes back on the next time the ignition is turned On, and then Off. © 2008 Directed Electronics. All rights reserved. -
Page 35: 2-Way Remote
(and on some cars the sunroof as well) with the key cylinder in the door. © 2008 Directed Electronics. All rights reserved. /disabled when the ignition is turned on or com- is a programming option which closes the vehicle’s win-... -
Page 36: Convenience Expansions
Power Window Control: Automatic power window control is provided with the 529T and 530T systems. These can operate power windows,and can roll them up automatically when the system is Locked, roll them down, or both up and down. © 2008 Directed Electronics. All rights reserved. -
Page 37: Glossary Of Terms
Valet Button: A small push button switch located on your systems control center. It is used to override the starter interrupt when a remote is lost or damaged, or to enter or exit Valet Mode. © 2008 Directed Electronics. All rights reserved. - Page 38 © 2008 Directed Electronics. All rights reserved.
-
Page 39: Quick Reference Guide
Press . The remote start LED turns on for 3-seconds and remote start tone sounds.. © 2008 Directed Electronics. All rights reserved. . The unlock LED flashes for one-second, and the re- The lock LED flashes for one-second The unlock LED flashes for one-... - Page 40 Exit the vehicle and lock the doors with the remote. The engine will remain running until the programmed time elapses or a shut-down input is received. (only after remote start is On.) . The unlock and funtion LEDs blink © 2008 Directed Electronics. All rights reserved. button...
-
Page 41: Limited Lifetime Consumer Warranty
Limited lifetime consumer warranty Directed Electronics. (“Directed”) promises to the original purchaser to repair or replace (at Directed’s election) with a comparable reconditioned model any Directed unit (hereafter the “unit”), excluding without limitation the siren, the remote transmitters, the associated... - Page 42 Authorized dealer’s company name and address Type of alarm installed Year, make, model and color of the automobile Automobile license number Vehicle identification number All security options installed on automobile Installation receipts © 2008 Directed Electronics. All rights reserved. 920-0003 06-06...
- Page 44 The company behind this system is Directed Electronics Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology.