Cleaning - Toro TimeCutter SW 5000 Operator's Manual

Hide thumbs Also See for TimeCutter SW 5000:
Table of Contents

Advertisement

Cleaning

Cleaning under the Front of
the Machine
Service Interval: After each use—Check and clean
the front of the mower.
Remove debris under the front of the machine with
compressed air or by hand with a brush
Note:
Do not use water to clean under the front of the
machine, this can cause buildup of debris.
Figure 61
Washing the Underside of
the Mower
Service Interval: After each use—Clean the mower
housing.
Important:
You can wash the machine with a mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the control panel, under the seat, around the
engine, hydraulic pumps, and motors.
Wash the underside of the mower after each use to
prevent grass buildup for improved mulch action and
clipping dispersal.
1.
Park the machine on a level surface and
disengage the blade-control switch.
2.
Ensure that the parking brake is engaged,
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Attach the hose coupling to the end of the
mower washout fitting, and turn the water on
high
(Figure
62).
Note:
Spread petroleum jelly on the washout
fitting O-ring to make the coupling slide on
easier and protect the O-ring.
(Figure
61).
1. Washout fitting
2. Hose
4.
5.
g028248
6.
7.
8.
48
Figure 62
Lower the mower to the lowest height of cut.
Sit on the seat and start the engine. Engage the
blade-control switch and let the mower run for 1
to 3 minutes.
Disengage the blade-control switch, shut off the
engine, and remove the ignition key. Wait for all
moving parts to stop.
Turn the water off and remove the coupling from
the washout fitting.
Note:
If the mower is not clean after 1 washing,
let it soak for 30 minutes. Then repeat the
procedure of washing the underside of the
mower.
Run the mower again for 1 to 3 minutes to
remove excess water.
WARNING
A broken or missing washout fitting
could expose you and others to thrown
objects or blade contact. Contact with
blade or thrown debris can cause injury
or death.
• Replace broken or missing washout
fitting immediately, before using
mower again.
• Never put your hands or feet under
the mower or through openings in the
mower.
g020098
3. O-ring
4. Coupling

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

74790Timecutter sw 54257478474793

Table of Contents