Storage - Toro TimeCutter SW 5000 Operator's Manual

Storage

Cleaning and Storage
1. Disengage the blade-control switch, move the
motion controls outward to the park position,
shut off the engine, and remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially
the engine. Clean dirt and chaff from the outside
of the engine cylinder head fins and blower
housing.
Important:
You can wash the machine with
a mild detergent and water. Do not pressure
wash the machine. Avoid excessive use
of water, especially near the control panel,
under the seat, around the engine, hydraulic
pumps, and motors.
3. Service the air cleaner; refer to Servicing the Air
Cleaner in the Engine Maintenance section.
4. Grease and oil the machine; refer to the
Lubrication section.
5. Change the crankcase oil and filter; refer
to Servicing the Engine Oil in the Engine
Maintenance section.
6. Check the tire pressure; refer to Checking the
Tire Pressure in the Drive System Maintenance
section.
7. Charge the battery; refer to Servicing the Battery
in the Electrical System Maintenance section.
8. Check the condition of the blades; refer to
Servicing the Cutting Blades in the Mower
Maintenance section.
9. Prepare the machine for storage when non-use
occurs over 30 days. Prepare the machine for
storage as follows.
10. Add a petroleum based stabilizer/conditioner
to the fuel in the tank. Follow the mixing
instructions from the stabilizer manufacturer. Do
not use an alcohol based stabilizer (ethanol or
methanol).
Note:
A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline and
used at all times.
Run the engine to distribute the conditioned fuel
through the fuel system (5 minutes).
Shut off the engine, allow it to cool, and drain
the fuel tank.
Start the engine and run it until it shuts off.
Choke the engine. Start and run the engine until
it will not start.
Dispose of fuel properly. Recycle according to
local codes.
Important:
stabilizer/conditioned gasoline over 90 days.
11. Remove the spark plug(s) and check its
condition; refer to Servicing the Spark Plug
in the Engine Maintenance section. With the
spark plug(s) removed from the engine, pour 2
tablespoons of engine oil into the spark plug
hole. Use the starter to crank the engine and
distribute the oil inside the cylinder. Install the
spark plug(s). Do not install the wire on the
spark plug(s).
12. Clean any dirt and chaff from the top of the
mower.
13. Scrape any heavy buildup of grass and dirt
from the underside of the mower, then wash the
mower with a garden hose.
14. Check the condition of the drive and mower
belts.
15. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is worn or
damaged.
16. Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service Dealer.
17. Store the machine in a clean, dry garage or
storage area. Remove the key from the ignition
switch and keep it in a memorable place. Cover
the machine to protect it and keep it clean.
49
Do not store