Raising The Front Of The Machine - Toro TimeCutter SW 5000 Operator's Manual

Raising the Front of the
Machine
If the front of the machine needs to be raised, use the
very front edge as show in
Important:
To prevent damage to the steering
mechanism, ensure that the very front edge of the
machine is used for jacking points.
Figure 23
Figure 23.
Lubrication
Greasing the Bearings
Service Interval: Every 25 hours—Grease all the
Grease Type: No. 2 lithium grease
1. Park the machine on a level surface, and
disengage the blade-control switch.
2. Ensure that the parking brake is engaged,
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings
25) with a rag.
Note:
Make sure to scrape any paint off the
front of the fitting(s).
g028320
1. Front caster tire
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance
2. Check the tire pressure
every 25 operating hours
4. Connect a grease gun to each fitting
and Figure
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
30
lubrication points.
(Figure 24
Figure 24
Figure 25
3. Grease every 25 operating
hours
4. Engine
25).
and Figure
g027752
decal106-8717
(Figure 24