Servicing The Fuses - Toro TimeCutter SW 5000 Operator's Manual

disconnect the charger leads from the battery
posts (Figure 38).
Figure 38
1. Positive battery post
2. Negative battery post
Installing the Battery
1. Position the battery in the tray
2. Install the positive (red) battery cable to the
positive (+) battery terminal using the fasteners
removed previously.
3. Install the negative battery cable to the negative
(-) battery terminal using the fasteners removed
previously.
4. Slide the red terminal boot onto the positive
(red) battery post.
5. Secure the battery with the hold-down
37).
6. Lower the seat.
g000538
3. Red (+) charger lead
4. Black (-) charger lead
(Figure 37).
(Figure

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows, check the
component/circuit for a malfunction or short.
Fuse:
•
Main F1-30 A, blade-type
•
Charge Circuit F2-25 A, blade-type
1. Remove the screws securing the control panel
to the machine. Retain all fasteners
2. Lift the control pane up to access the main wire
harness and fuse block
3. To replace a fuse, pull out on the fuse to remove
it (Figure 39).
1. Main—30 A
4. Return the control panel to its original position.
Use the screws removed previously to secure
the panel to the machine.
38
(Figure 39).
Figure 39
2. Charge circuit—25 A
g014540