Operating Tips - Toro TimeCutter SW 5000 Operator's Manual

Operating Tips

Using the Fast Throttle Setting
For best mowing and maximum air circulation, operate
the engine at the F
AST
thoroughly cut grass clippings, so do not set the height
of cut so low as to totally surround the mower by uncut
grass. Always try to have 1 side of the mower free
from uncut grass, which allows air to be drawn into
the mower.
Cutting a Lawn for the First Time
Cut grass slightly longer than normal to ensure that
the cutting height of the mower does not scalp any
uneven ground. However, the cutting height used in
the past is generally the best one to use. When cutting
grass longer than 15 cm (6 inches) tall, you may want
to cut the lawn twice to ensure an acceptable quality
of cut.
Cut a Third of the Grass Blade
It is best to cut only about a third of the grass blade.
Cutting more than that is not recommended unless
grass is sparse, or it is late fall when grass grows
more slowly.
Alternating the Mowing Direction
Alternate the mowing direction to keep the grass
standing straight. This also helps disperse clippings
which enhances decomposition and fertilization.
Mowing at Correct Intervals
Grass grows at different rates at different times. To
maintain the same cutting height, mow more often in
early spring. As the grass growth rate slows in mid
summer, mow less frequently. If you cannot mow for
an extended period, first mow at a high cutting height,
then mow again 2 days later at a lower height setting.
Avoiding Cutting Too Low
If the cutting width of the mower is wider than the
mower you previously used, raise the cutting height to
ensure that uneven turf is not cut too short.
Using the Slower Cutting Speed
To improve cut quality, use a slower ground speed
in certain conditions.
Stopping the Machine
If you must stop the forward motion of the machine
while mowing, a clump of grass clippings may
position. Air is required to
drop onto your lawn. To avoid this, move onto a
previously cut area with the blades engaged or you
can disengage the mower deck while moving forward.
Keeping the Underside of the
Mower Clean
Clean clippings and dirt from the underside of the
mower after each use. If grass and dirt build up
inside the mower, cutting quality eventually becomes
unsatisfactory.
Maintaining the Blade(s)
Maintain a sharp blade throughout the cutting season
because a sharp blade cuts cleanly without tearing or
shredding the grass blades. Tearing and shredding
turns grass brown at the edges, which slows growth
and increases the chance of disease. Check the
cutter blades daily for sharpness, and for any wear or
damage. File down any nicks and sharpen the blades
as necessary. If a blade is damaged or worn, replace
it immediately with a genuine Toro replacement blade.
28