Drive System Maintenance - Toro TimeCutter SW 5000 Operator's Manual

Drive System
Maintenance
Checking the Tire Pressure
Service Interval: Every 25 hours—Check tire
pressure.
Maintain the air pressure in the front and rear tires as
specified. Uneven tire pressure can cause uneven
cut. Check the pressure at the valve stem
Check the tires when they are cold to get the most
accurate pressure reading.
Refer to the maximum pressure suggested by the tire
manufacturer on the sidewall of the caster wheel tires.
Inflate the rear drive wheel tires to 90 kPa (13 psi).
Figure 40
1. Valve stem
Releasing the Electric
Brake
Manually rotate the link arms to release the electric
brake. Once the electric brake is energized the brake
resets.
To release the brake:
(Figure 40).
1. Brake link arm on the electric-brake-control module
2. Left, rear tire
g000554
1. Turn the ignition key to the O
disconnect the battery.
2. Locate the shaft on the electric brake where the
brake link arms are connected.
3. Rotate the shaft forward to release the brake.
39
Figure 41
position or
FF
g027911