Positioning The Seat - Toro TimeCutter SW 5000 Operator's Manual

Positioning the Seat

Figure 15
Positioning the Steering
Wheel
The steering wheel has 3 positions for operation and
1 full-up position. Use the full-up position for stepping
on and off the machine and getting out of the seat.
When operating the machine, position the steering
wheel where you have the best control of the machine
and are most comfortable.
1. Press your foot onto the steering-column release
lever.
2. Position the steering wheel to the desired
position (Figure 16).
Adjusting the Anti-scalp
Rollers (for 107 cm (42-inch)
g027249
Mower Decks)
Whenever you change the height of cut, it is
recommended to adjust the height of the anti-scalp
rollers.
Note:
Adjust the anti-scalp rollers so the rollers do
not touch the ground in normal, flat mowing areas.
1. Disengage the blade-control switch (PTO) and
ensure that the parking brake is engaged.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers to 1 of the following
positions:
•
Upper hole—use this position with the mower
deck in the 63 mm (2-1/2 inches) and below
the height-of-cut positions
•
Lower hole—use this position with the mower
deck in the 76 mm (3 inches) and above the
height-of-cut positions
23
Figure 16
(Figure 17).
(Figure 17).
g027751