Raising The Front Of The Machine; Lubrication; Greasing The Bearings - Toro 74790 Operator's Manual

Raising the Front of the
Machine
If you need to raise the front of the machine, use the
very front edge as shown in
Important:
To prevent damage to the steering
mechanism, ensure that the very front edge of the
machine is used for jacking points.
Figure 23
Figure 23.
g028320

Lubrication

Greasing the Bearings

Service Interval: Every 25 hours—Grease all the
lubrication points.
Grease Type: No. 2 lithium grease
1. Park the machine on a level surface, and
disengage the blade-control switch.
2. Engage the parking brake, shut off the engine,
remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Clean the grease fittings with a rag
and Figure 25).
Note:
Make sure to scrape any paint off the
front of the fitting(s).
1. Front caster tire
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance.
2. Check the tire pressure
every 25 operating hours.
4. Connect a grease gun to each fitting
and Figure 25).
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
31
(Figure 24
Figure 24
Figure 25
3. Grease every 25 operating
hours.
4. Engine
(Figure 24
g027752
decal106-8717