User Setup Prompts - Precor Treadmill EFX534 Owner's Manual

Light commercial efx series
Table of Contents

Advertisement

C
O
M
M
E
R
C

USER SETUP PROMPTS

Precor banner: The Precor banner and course profiles appear in the center dis-
play. Always start a workout at the Precor banner.
Important: Because the EFX is self-powered, the Precor banner does not appear
until the user maintains a stride rate above 40 strides per minute. Note that there
is an exception to this rule. If power is being supplied through the optional battery
recharger, then pedaling is not required prior to entering a course. Refer to page 7,
EFX
®
Self-powered Features.
Setup prompts appear in the center display prior to your workout. You address
each prompt using the keypad keys.
Keypad use during
Setup Prompts
▼ or ▲
Select
Reset
QuickStart
Enter
COURSE prompt: The EFX provides 5 course selections. The first course selection
to appear on the display is MANL (Manual course). Use any ▼▲ key to change the
selection. Press Enter to accept the displayed name. Have the user refer to the
display label on the console to determine which abbreviations represent the differ-
ent course selections. For a description of the courses, refer to page 40.
Important: If you press QuickStart while a course selection is displayed, the
course begins. Refer to Using QUICKSTART during the Setup Prompts .
Note: If no key press is detected for ten seconds, the display prompts the user on
what to do next. If no key press is detected for two minutes or the RESET key is
pressed, the display returns to the banner.
Workout Time prompt: A default value of 30 minutes (or the custom settings
limit, whichever is less) appears. Use any ▼▲ key to change the workout time.
For MANL, XTR, and INTV courses, the workout time may be set as low as one
minute or as high as the custom settings limit. Press Enter or QuickStart to
accept the displayed value.
page 28
I
A
L
P
R
O
D
Description
Scrolls through the selections. The longer the key is held
down, the faster the selections scroll past.
Acts the same as the Enter key.
Exits the Setup Mode and returns the display to the
Precor banner.
Bypasses any remaining Setup prompts and accesses
the course selection. Refer to Using QuickStart During
the Setup Prompts on the opposite page.
Submits the displayed selection and moves onto the next
Setup prompt.
U
C
T
S
D
I
V
I
S
I
O
N

Advertisement

Table of Contents
loading

Table of Contents