Table of Contents
Advertisement
C
O
M
M
E
R
C
SUPPLYING POWER TO THE EFX534
The EFX does not require an electrical power connection. It has an internal battery
that is recharged every time a user works out for a reasonable period of time. A
pedaling speed above 40 strides per minute must be maintained for several seconds
before the Precor banner appears on the display. Once the banner appears, the user
can press QuickStart or Enter to begin working out. For more information, refer to
page 34, Exercising on the EFX .
TESTING THE HEART RATE DISPLAY
If you have purchased the optional POLAR
display is operational before customers begin using the machine.
Note: To conduct electrical impulses from a user's heart, the electrode strips on
the chest strap must be in contact with the user's skin. Usually, the concentration
of salts in a person's perspiration provides enough conductivity to transmit a
signal to the receiver in the display console. However some people, because of
body chemistry or erratic heart beats cannot use the heart rate feature on the
EFX. To purchase a POLAR
Diagram 20 Wearing the POLAR
chest strap.
®
POLAR
chest strap
positioned and
centered on chest.
®
POLAR
chest strap
electrode strips
Dampen with water.
1. Wet the electrode strips on the POLAR
chest as shown in Diagram 20. Adjust the strap so that it maintains a snug fit.
2. Hold onto the stationary handrail and step onto the foot pedals.
3. Begin pedaling and maintain a stride rate above 40 strides per minute. The
Precor banner will appear on the display.
4. Wait five to ten seconds. A number indicating your heart rate (beats per minute)
should appear in the display. Three dashes appear (— — —) if a heart beat is
detected, but interference is occurring. Try readjusting the chest strap.
5. If the heart rate display appears, the cables are properly connected and the
heart rate feature can be a viable part of a user's workout.
6. If the heart rate display does not appear, press Reset to return to the Precor
banner and then, ask someone else to try steps 2 through 4. If no heart rate
number appears, reconnect the cables at the front of the base tube. Follow
steps 1 through 4, again.
If a heart rate cannot be detected, refer to Obtaining Service on page 7.
page 22
I
A
L
P
R
O
D
®
chest strap, refer to Obtaining Service on page 7.
®
U
C
T
S
D
I
V
®
chest strap, verify that the heart rate
®
chest strap and wrap it around your
I
S
I
O
N
Advertisement
Table of Contents
