Table of Contents
Advertisement
C
O
M
M
E
R
C
13. Connect the cable. Diagram 8, inset. Insert the cable into its receptacle.
Just like a telephone connection, a definite "click" is heard when a good
connection is made. If you do not hear a "click," try reinserting the cable
connection again.
14. Push excess cable inside base tube. Diagram 8. Carefully, push any excess
cable behind the height adjustor threads that protrude from inside the base tube.
Diagram 9
Place the base
on supportive
blocks.
Adjustable rear pad
Base assembly
Supportive
wedge
15. Rotate the rear pads. Diagram 9, inset. Ask your assistant to stabilize the
unit while you rotate the rear adjustable pad to the highest position. This
procedure lifts the base assembly off the floor which provides better access
to the fasteners.
16. Place the base assembly on the supportive wedge. Diagram 9. Have an
assistant grasp and lift the upright support so that you can slide a wedge
(packing material) under the front of the unit.
I
A
L
P
R
O
D
U
C
T
S
D
I
V
I
S
I
O
N
page 15
Advertisement
Table of Contents
