Table of Contents
Advertisement
C
O
M
M
E
R
C
Diagram 4
Front base assembly.
Plastic grommet
Front base tube
Height adjustor
Tighten the height
adjustor so that the
nut is secure against
the front tube.
Cut the tie wrap that
secures the grommet
to the cable.
4. Cut the tie wrap securing the front base tube to the pallet. Discard the tie
wrap.
5. Thread the height adjustor to its lowest position. Diagram 4, #1 and #2.
Remove the height adjustor from the Hardware kit. Ask an assistant to lift the
front base tube while you insert the height adjustor. Turn the height adjustor so
that the threads appear inside the base tube. Tighten the nut (with a crescent
wrench) when the height adjustor is fully threaded into the front base tube.
6. Cut the tie wrap holding the plastic grommet. Diagram 4, #3. Use a wire
cutter (or scissors) to remove the plastic grommet from the cable.
Diagram 5
Front base assembly.
Plastic grommet
Cable receptacle
Front base assembly
7. Insert the plastic grommet. Diagram 5. Place the grommet into the hole on
the front base assembly. Press down so that it snaps into place.
page 12
I
A
L
P
R
O
D
1
2
U
C
T
S
D
I
V
3
I
S
I
O
N
Advertisement
Table of Contents
