Alcatel-Lucent OmniSwitch 6250-M Hardware User's Manual page 71

Mounting OS6250 Switches
5
Once the holes are aligned, insert a rack mount screw (not provided) through the bottom hole of each
flange. Tighten both screws until they are secure.
When rack mounting, a clearance of
0.875 inches is recommended above
the chassis.
Rack-mounting Chassis with Power Supply Tray - Update
When rack mounting, a clearance of
0.875 inches is recommended above
the chassis.
Note. Be sure to install the screws in the bottom hole of each flange, as shown, before proceeding.
6 Once the screws at the bottom of each flange are secure, install the remaining two rack mount screws.
Be sure that all screws are securely tightened.
OmniSwitch 6250 Series Hardware Users Guide
Preliminary
9/28/09
No minimum clearance is required below the chassis
assembly. However, be sure that the bottom of the chassis
is not in direct contact with any equipment below.
No minimum clearance is required below the chassis
assembly. However, be sure that the bottom of the chassis
is not in direct contact with any equipment below.
Rack-mounting Two Chassis
September 2009
Mounting OS6250 Switches
page 3-15