Seat Installation (Various Models) - Huffy Coaster Owner's Manual

Seat Installation (various models)

Seat to Seat Post (Single Bolt Style): Some models are
equipped with a seat and seat post assembly that uses a single
bolt and nut to secure the seat to the seat post. The seat is as-
sembled to the seat post at the factory
Ensure the seat is secure to the seat post and the seat bolt is
tightened. See torque table for recommended torque.
WARNING: To prevent the
seat coming loose and possible loss
of control, the "MIN-IN" (minimum
insertion) mark
must be below the top of the Seat
Tube C .
SEAT AND SEAT POST SETUP:
1. If needed, loosen Nuts on Seat
Clamp
D
riding position.
2. Ensure the Seat Post
through the TOP Seat Clamp
.
D
3. Tighten the Seat Clamp so the Seat does not move on the seat post. See
torque table for recommended torque.
4. If the Seat Clamp has a Nut on each side, tighten both nuts equally.
5. Point the Seat forward and put the Seat Post
proceed to next step.
TIGHTEN THE QUICK RELEASE LEVER:
NOTE: The words "open" and "close" are on oppo-
site sides of the quick release lever.
1. Move the Quick Release Lever
position so the word "open" is pointing away
from the Seat Post Clamp
CAUTION: Operate the Quick Release Lever
F by hand only. Do not use a hammer or any other
tool to tighten the quick release lever.
2. You must use strong force to move the quick
release lever to the "close" position. If you can
12 easily move the lever to the "close" position, the clamping force is too light.
B on the Seat Post
and rotate Seat into
is fully
E
G
.
A
E
B
g B
E
to the "open"
F
.
A
D
C
into the Seat Tube
H
g A
B
and
C
g C
E
C
G
F