Seat Installation (Various Models) - Huffy BMX Owner's Manual

Seat Installation
WARNING
"MIN-IN" (minimum insertion) mark
C
Tube .
SEAT AND SEAT POST SETUP:
1. If needed, loosen Nuts on Seat
D
Clamp and rotate Seat into rid-
ing position.
2. Ensure the Seat Post
through the TOP Seat Clamp
3. Tighten the Seat Clamp so the Seat
does not move on the seat post.
4. If the Seat Clamp has a Nut on each
side, tighten both nuts equally.
5. Point the Seat forward and put the
Seat Post E into the Seat Tube
and proceed to next step.
TIGHTEN THE QUICK RELEASE LEVER:
NOTE: The words "open" and "close" are on opposite sides of the quick release lever.
CAUTION: Operate the Quick Release Lever
by hand only. Do not use a hammer or any other tool to
tighten the quick release lever.
1. Move the Quick Release Lever
tion so the word "open" is pointing away from the Seat
G
Post Clamp
WARNING
the quick release lever to the "close" position. If you can
easily move the lever to the "close" position, the clamping
force is too light. If the clamping force of the Quick Release
Lever is too light, the seat post can loosen while riding.
This can cause injury to the rider or to others.
2. Open and close the Quick Release Lever with one hand while you turn the Adjusting Nut
H
with the other hand.
3. Tighten or loosen the adjusting nut by hand, so that you fi rst feel resistance to the quick
release lever when it perpendicular to the bicycle frame.
4. Push the Quick Release Lever to the "close" position.
5. When in the "close" position, make sure the Quick Release Lever lays against the Seat
: To prevent the Seat
B
E
is fully
D .
C
F to the "open" posi-
.
: You must use strong force to move
A
coming loose and possible loss of control, the
on the Seat Post must be below the top of the Seat
A
E
B
g A
F
B
D
C
H
g B
E
C
G
F
17