Seat Installation - Huffy Cruiser Owner's Manual

Seat Installation

Attach Seat to Seat Post (fi g 09):
(pre-assembled on some models)
• Loosen nuts on seat clamp (A)
and rotate Seat (14) into riding
position.
• Put the seat post (33) fully through
the seat clamp (A).
• Tighten the Seat Clamp (A) so the
seat (14) stays on the seat post.
• If the Seat Clamp has a nut on
each side, tighten both nuts
equally.
CAUTION: If you accidentally drop the seat post into the seat tube, it
may be diffi cult to remove it.
• Point the Seat (14) forward and
put the Seat Post (33) into the
Seat Tube (B) (fi gs 10, 11).
WARNING: To prevent the seat
coming loose and possible loss of
control, the "MIN-IN" (minimum inser-
tion) mark (C) on the seat post must
be below the top of the Seat Tube (B).
Tighten the quick release lever:
• Move the Quick Release Lever (D)
to the "open" position so the word
"open" is pointing away from the
Seat Post Clamp (E).
NOTE: The words "open" and "close"
are on opposite sides of the quick
release lever.
16
14
33
C
F
Meijer.com
A
33
fig 09
C
14
B
B
fig 10
33
B
E
D
fig 11