Huffy Coaster Owner's Manual page 17

Training Wheels - continued
Adjusting Training Wheel Height:
1. Make sure both Training Wheels are the
same distance from the ground (1/8in
(3.17mm)) and pointing straight down.
2. Tighten Axle Nuts
See torque table for recommended
torque.
OPERATION:
WARNING: Before each ride, make sure both axle nuts are tight. Also make sure
both training wheels are the same distance from the ground.
As your child's ability improves, you may raise and eventually remove the training wheels.
Raising the training wheels little by little will help them learn to ride on the bike's two
wheels.
• To move the training wheels, loosen the axle nuts, slide the leg to the correct posi-
tion, and retighten the axle nuts.
• To remove the training wheels, remove the Axle Nuts
D . Then reinstall Axle Nut over Alignment Tab
WARNING:
Failure to reinstall Axle Nuts can cause injury to the rider or to others.
WARNING: When riding with training wheels:
• Ride only on level areas.
• Do not ride on steep hills, uneven sidewalks, or near steps. The bicycle can tip over if a
training wheel goes off the edge of the riding surface.
• Ride straight up and down sloped surfaces, because the bicycle can tip over when rid-
ing across sloped surfaces.
• Slow down at corners because you can not turn as quickly as bicycles without training
wheels.
A
securely.
A
1/8"
(3.17mm)
A and Training Wheel Legs
C and tighten securely.
A
1/8"
17