Seat Installation - Huffy KD58C-LCD Owner's Manual

WARNING:
"MIN-IN" (minimum insertion) mark
B
seat tube .
STEP 1
- INSERT SEAT POST INTO SEAT TUBE:
• If needed, loosen seat post clamp screw
the quick release lever
• Point the seat forward and put the seat post
the seat tube B
the top of the seat tube as shown.
STEP 2
- BOLT SEAT CLAMP: (various models)
• With seat post C
Tighten screw D
without moving.
STEP 3
- QUICK RELEASE LEVER: (various models)
CAUTION
: Operate the quick release lever by HAND
ONLY - DO NOT USE TOOLS.
1. As needed, open and close the quick release lever
with one hand and tighten or loosen the adjusting
G
nut by hand, so that you fi rst feel resistance to the
quick release lever when it is in the "OPEN" position
1 .
2. Push the quick release lever to the "CLOSE" position
- It will take strong force to clamp securely so
2
that the quick release Lever lays against the seat
post clamp F .
WARNING:
move the quick release lever securely to the "CLOSE"
position . This ensures that the seat does not move
2
during normal operation.
NOTE: I
Suggested Torque 20-22NM - Verify seat does not move
while riding.
REFLECTOR:
(as equipped)
Position seat post refl ector (if equipped)
backwards. Tighten clamp screw.

Seat Installation

To prevent the seat coming loose and possible loss of control, the
A
E .
with the "MIN-IN" marks BELOW
inserted according to STEP 1 -
securely so seat supports the rider
You must use strong force to
on the seat post must be BELOW the top of the
or open
D
C into
A
E
C
G
H so it points straight
A
C
B
C
D
F
2
E
I
1
2
3
1
H
15