Show Uidb Data - Cisco ASR 9000 Series Command Reference Manual

show uidb data

show uidb data
To display index data information for the micro-interface descriptor block (uIDB), use the show uidb
datacommand in EXEC mode.
show uidb data [shadow] [ingress| egress] [interface-type interface-instance] location node-id
Syntax Description
shadow
ingress
egress
interface-type
interface-instance
location node-id
Command Default
No default behavior or values
Command Modes
EXEC
Cisco ASR 9000 Series Aggregation Services Router Advanced System Command Reference, Release 4.0
34
(Optional) Displays uIDB data from shadow copy Route Skill Mapping (RSM) instead
of Metro HW.
(Optional) Displays ingress PSE-related information.
(Optional) Displays egress PSE-related information.
Interface type. For more information, use the question mark (?) online help function.
Either a physical interface instance or a virtual interface instance as follows:
• Physical interface instance. Naming notation is rack/slot/module/port and a slash
between values is required as part of the notation.
◦ rack: Chassis number of the rack.
◦ slot: Physical slot number of the modular services card or line card.
◦ module: Module number. A physical layer interface module (PLIM) is
always 0.
◦ port: Physical port number of the interface.
Note In references to a Management Ethernet interface located on a route
processor card, the physical slot number is alphanumeric (RP0 or RP1)
and the module is CPU0. Example: interface MgmtEth0/RP1/CPU0/0.
• Virtual interface instance. Number range varies depending on interface type.
For more information about the syntax for the router, use the question mark (?) online
help function.
Displays micro-IDB index data information for a specified node. The node-id
argument is entered in the rack/slot/module notation.
Troubleshooting Commands