show tech-support aps
show tech-support aps
To automatically run show commands that display debugging information related to automatic protection
switching (APS), use the show tech-support aps command in the EXEC mode. This command collects APS
traces and sonet local traces across all locations and also show controller and show aps commands for all
ports and groups.
show tech-support aps file send-to [group| show-only] [location node-id]
Syntax Description
file
send-to
group
show-only
terminal
location
node-id
Cisco ASR 9000 Series Aggregation Services Router Advanced System Command Reference, Release 4.0
56
Specifies that the command output is saved to a specified file.
Name of the file. The following valid options are listed:
• filename
• bootflash: filename
• compactflash: filename
• disk0: filename
• disk1: filename
• flash: filename
• ftp: filename
• harddisk: filename
• harddiska: filename
• nvram: filename
• rcp: filename
• slot0: filename
• slot1: filename
• tftp: filename
(Optional) Displays the show group commands with no trace for APS debugging.
(Optional) Displays the show commands with no trace for APS debugging.
(Optional) Specifies that the command output is displayed on the terminal.
(Optional) Specifies a node.
(Optional) Node ID. The node-id argument is entered in the rack/slot/module
notation.
Tech-Support Commands