Headlight Aiming Control - Renault ALASKAN 2017 Driver's Handbook Manual

HEADLIGHT AIMING CONTROL

(where fitted)
Manual type
The headlight aiming control operates when the ig-
nition switch is in the ON and the headlight switch is
in the position to allow the headlight axis to be
adjusted according to the driving condition.
When driving with no heavy load/luggage or driving
on a flat road, select the normal position <0>.
If the number of occupants and load/luggage in the
vehicle changes, the headlight axis may become
higher than normal.
If the vehicle is travelling on a hilly road, the head-
lights may directly shine on the rearview and outside
mirrors of a vehicle ahead or the windscreen of an
oncoming vehicle, which may obscure another driv-
ers' vision.
2-32
Instruments and controls
To adjust to the proper aiming height, turn the switch
accordingly. The higher the number, designated on
the switch, the lower the headlight axis.
Automatic type
For vehicles fitted with an automatic levelling sys-
tem, the headlight axis is controlled automatically.
BATTERY SAVER SYSTEM
(where fitted)
The light reminder chime will sound if the headlight
switch is in either the
when the driver's door is opened with the ignition
switch in the ACC, OFF or LOCK position.
JVI0477XZ
If the ignition switch is placed in the OFF or LOCK
position while the headlight switch is in the
position, the battery saver function will turn off
the lights after a period of time to prevent the battery
from being discharged.
CAUTION
Do not leave the lights on when the engine is not
running for extended periods of time to prevent
the battery from being discharged.
TURN SIGNAL SWITCH
or position and
CAUTION
The turn signal switch will not be cancelled auto-
or
matically if the steering wheel turning angle does
not exceed the preset amount. After the turn or
lane change, make sure that the turn signal
switch is returned to its original position.
Turn signal
To turn on the turn signals, move the lever up
down
the turn is completed, the turn signal cancels auto-
matically.
Lane change signal
To turn on the lane change signals, move the lever
up or down
gins to flash.
If the lever is moved back to its original position right
after moving up or down, the light will flash 3 times.
to the point where the lever latches. When
to the point where the light be-
NIC2915
or