Renault ALASKAN 2017 Driver's Handbook Manual page 43

4. Remove any additional slack from the seat belt;
press downward and rearward
the centre of the child restraint with your knee to
compress the vehicle seat cushion and seatback
while pulling up on the seat belt.
Front-facing: Step 5
5. Test the child restraint before you place the child
in it . Push the child restraint from side to side
and tug it forward to make sure that it is held
securely in place.
6. Check to make sure that the child restraint is
properly secured prior to each use. If the child
restraint is loose, repeat steps 3 through 5.
Rear-facing child restraint:
firmly in
Be sure to follow the manufacturer's instructions for
the proper use of your child restraint. Follow these
steps to install a rear-facing child restraint on the
rear seats using three-point type seat belt without
automatic locking mode:
SSS0638AZ
Rear-facing: Step 1
1. Position the child restraint on the seat
Rear-facing: Step 2
2. Route the seat belt tongue through the child re-
straint and insert it into the buckle
hear and feel the latch engage.
3. To prevent slack in the seat belt webbing, it is
necessary to secure the seat belt in place with
locking devices attached to the child restraint.
4. Remove any additional slack from the seat belt;
press downward
SSS0759AZ
the centre of the child restraint with your hand to
compress the vehicle seat cushion and seatback
.
while pulling up on the seat belt.
SSS0654AZ
until you
Safety — seats, seat belts and supplemental restraint system
SSS0639AZ
Rear-facing: Step 4
and rearward firmly in
SSS0658AZ
Rear-facing: Step 5
1-25