Renault ALASKAN 2017 Driver's Handbook Manual page 230

4WD mode
Wheels driven
switch
<2WD> Rear wheels
Four wheels
<4H>
Neutral
<4LO>
Four wheels
*: When the <4LO> position is selected, the
ESP system is disabled and the ESP off
indicator light illuminates. See "Warning lights,
indicator lights and audible reminders" in the
"2. Instruments and controls" section.
5-28
Starting and driving
Indicator
4WD mode <4LO>
m -
m -
m
Blinking
m Stay on*
Operation of 4WD mode switch
Use conditions (See "4WD mode switch operation" later in this
Shifting between the <2WD> and <4H> drive
For driving on dry,
modes can be done while driving.
paved roads.
The indicator will change when the drive mode is
changed.
For driving on rough,
Shifting between the <2WD> and <4H> modes
sandy or snow-
must be performed at a speed below 100 km/h
covered roads.
(60 MPH).
Shifting between the <4H> and <4LO> drive
The 4LO indicator
modes:
blinks when shifting
• Stop the vehicle, depress the clutch pedal (MT
between <4H> and
models) and the brake pedal and shift the shift
<4LO>.
lever to the N (Neutral) position.
For use when
• Depress and turn the 4WD mode switch. The
maximum power and
4WD mode switch will not shift between <4H>
traction are required
and <4LO> if the transmission is not in the N
at low speeds (for
(Neutral) position or the vehicle is moving.
example, on steep
• Wait for the 4LO indicator to stop blinking and
grades or rocky,
stay on or off before shifting your transmission
sandy, muddy
into gear or releasing the clutch pedal (MT
roads).
models).
section.)