Rack-Mounting The Chassis; Attaching Rack-Mount Brackets To Cisco 2010 Cgr Routers - Cisco 2010 Hardware Installation Manual

Chapter 3 Installing and Connecting the Router
R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
To prevent damage to the chassis, never attempt to lift or tilt the chassis by holding it by the plastic panel
Caution
on the front. Always hold the chassis by the sides of the metal body.
Allow at least one rack unit of vertical space above the router.
Note

Rack-Mounting the Chassis

Cisco 2010 CGR can be installed in 19-inch (48.26-cm) standard rack.
You can mount the router in the following ways:
•
•
Figure 3-2
Figure 3-1

Attaching Rack-Mount Brackets to Cisco 2010 CGR Routers

For the Cisco 2010 CGR routers, use four of the supplied number-8 Phillips flat-head screws to attach
the long side of each bracket to the router.
Figure 3-2
OL-21559-01
Power supply side mounting—Brackets attached at the power supply side of the chassis with the
power supply side facing forward.
Cable side mounting—Brackets attached at the cable side of the chassis with the cable side facing
forward.
shows the rack-mount brackets used with the Cisco 2010 CGR.
Rack-Mount Brackets for the Cisco 2010 CGR
shows how to attach the brackets to the sides of the router with the power supply side forward.
Cisco Connected Grid Routers 2010 Hardware Installation Guide
Installing the Router in a Rack
3-5