Cisco 2010 Hardware Installation Manual page 47

Chapter 3 Installing and Connecting the Router
R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
• Installing the Cisco Microsoft Windows 2000 USB Driver
Installing the Cisco Microsoft Windows Vista USB Driver
•
Note
Connect the end of the cable with the DB-9 connector (or USB Type-A) to the terminal or PC. If your
Step 2
terminal or PC has a console port that does not accommodate a DB-9 connector, you must provide an
appropriate adapter for that port.
To identify the COM port assigned to the USB console port, use the Control Panel to open the Device
Note
Manager, and expand the Ports section. The assigned COM port is shown in parenthesis at the end of the
line with the following entry: Cisco USB System Management Console.
To communicate with the router, start a terminal emulator application, such as Microsoft Windows
Step 3
HyperTerminal. This software should be configured with the following parameters:
9600 baud
•
8 data bits
•
no parity
•
1 stop bit
•
no flow control
•
OL-21559-01
You cannot use the USB port and the EIA port concurrently. See the
Auxiliary Port" section on page
EIA port.
Connecting to a Console Terminal or Modem
3-16. When the USB port is used, it takes priority over the RJ-45
Cisco Connected Grid Routers 2010 Hardware Installation Guide
"Connecting to the
3-11